As Muetze said, pin 13 in connector D (U14 St DSP - Radio On) should give you a switched 12V+ which is on when the radio is on. However, the RNS-E does not immediatly power off its amp when it shuts down. It may take up to 30 minutes before the amp (and devices connected to that pin) power off.
This list of phones has been tested in the UK with an EU RNS-E running the 2005_2 SW 0360 and FW 050. You may find differences with lower revisions of SW or US devices.
So far paired and Hands free profiles for...
SE K700i
SE K750i
SE S700i
Nokia 6021
Nokia 6800
Nokia 6822
Nokia 6230...
Hello,
Today I recieved a brand new 2012 bjarne CANGATE, and I have doubts about it's installation, first of all how I can configure the CANGATE, it has to be with vag-com or directly with the usb port?
And the other question is, now i have te RNS-e coded in A6 4B with the CANGATE i have to...
I have an OEM Audi Bluetooth module (8P1 862 335 A) added to my RNS-E in my B6 A4. I also have a Ross-Tech Hex+CAN USB cable along with the latest version of VCDS (15.7.0.1). When scanning the control module (77 Telephone), I'm getting the following error:
Address 77...
Hello,
I did a lot of search and saw some similar problem reported but could not find the solution unfortunately.
I have a databus error in my setup after recent retrofit work.
01305 - Databus for Infotainment
004 - No Signal/Communication - Intermittent
Here is where I started:
2002 allroad...
i got an AMI unit from an R8 (came without any harness) and I built my harness myself. I found all the necessary information here on this site but one question remains slightly unclear. Do the 3 audio wires from AMI that go to 32 pin connection at the back if RNS-E connect to NF-in or AUX NF-in...
A forum community dedicated to all Audi owners and enthusiasts. Come join the discussion about performance, modifications, Quattro systems, turbos, troubleshooting, maintenance, and more!