Audi Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
84 Posts
Discussion Starter · #1 ·
Hi
completed installation of nav+ with tmc in A4 3.0l quattro, all is well except one problem ,hooked up vagcom to change some codes(module 17 instruments)to include multi function wheel + nav display in cluster,after recode wheel works perfectly but still cd & radio show in cluster but no nav route in cluster.Any ideas :?
 

·
Registered
Joined
·
84 Posts
Discussion Starter · #6 ·
AudiA4B6US said:
My DIS does not always detect that my RNS-E is sending navi data. Turning the RNS-E off and back on makes the data appear on the DIS. In any case, there is only data displayed from the RNS-E when your route guidance is active or when you set the RNS-E to display the compass in the DIS. Could this be the issue you are seeing?
when using vagcom i cannot access module 37(navigation)could this have anything to do with it also on the plug&play harness supplied with nav unit there were 4 loose wires (GALA,ILL,K-DIAGNOSTIC,12V+)i did not connect 12v+ or k-diagnostic cos i didn,t where to connect will this cause problems
 
1 - 2 of 2 Posts
Top