Audi Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter #1
Can anyone confirm that all the necessary coding can be done using release 311.2 of the vag-com software. THANKS. (buying the tool from obdtool.com, but their tool only supports up to release 311.2)
 

·
Super Moderator
Joined
·
11,350 Posts

·
Registered
Joined
·
18 Posts
Do you use the shareware version or the full version?

I need to adapt my rns-e to my car A4 B5. Can I do this with the shareware version or need I the full version?
 

·
Registered
Joined
·
6,767 Posts
AFAIK you cannot make changes with the shareware version, just read fault codes. To program the RNS-E or clear faults you will need the full version...
 

·
Super Moderator
Joined
·
11,350 Posts
AudiA4B6US said:
AFAIK you cannot make changes with the shareware version, just read fault codes. To program the RNS-E or clear faults you will need the full version...
See here for the differences between the shareware and registered versions of VAG-COM http://www.ross-tech.com/vag-com/vag-functions.html

This is what makes the shareware version no use setting up an RNS-E:

Ross-Tech said:
Shareware Limitation(s):

The Unregistered/Unactivated version of VAG-COM will only allow access to the first 9 Adaptation Channels (out of 99 possible).

The Save Function is Blocked.
Since you need the Save function on Adaptation Channels, AND you need to access Adaptation Channels higher than 9 (e.g. channel 62 of the DIS)- this makes the shareware version of VAG-COM not usable for a proper setup of an RNS-E. You can recode it, but that's about all.
 
1 - 7 of 7 Posts
Top