Audi Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
19 Posts
Discussion Starter · #1 ·
Does anyone know if there is a special VAG Code that allows me to activate satellite radio (XM)? No matter how long I wait, XM will not activate after a refresh from the site. I've tried two different XM boxes for the RNS-E and have verified that I have the right unit.



I found this label file on Ross Tech, specifically for the A6 and noticed that there is a block to read activation after the ESN.

Any help would be appreciated. Thanks.


;
; measuring block information
;
;---------------------------------------------------
;
;
001,0,General
001,1,Voltage,(Terminal 30),Specification: 9.0...15.0 V
;
002,0,MOST-Databus
002,1,Dynamic Address,(MOST-Databus)
002,2,Message Identity
002,3,Optical Transm.,Power Reduction
;
003,0,Diagnostic Wire
003,1,Electrical Coding
003,2,Diagnostic Wire,,0 = Loop Break Diagnosis active\n1 = Databus static
;
004,0,Electronic Serial Number (ESN)
004,1,Activation Code
;
005,0,Signal Status
005,1,Signal Quality,,1 = No Signal available \n2 = Too weak\n3 = OK\n4 = Optimal
005,2,Audio Signal,present,Display Range: Yes/No
;
007,0,Contrl Module Status
007,1,Bounded,,Display Range: Yes/No
007,2,Subscribed,,Display Range: Yes/No
;
008,0,Service Information
008,1,Provider,Information
008,2,Satellite,Antenna Status,0 = OK or Open Circuit\n1 = Short to Ground\n2 = Short to Plus
008,3,Terrestrical,Antenna Status,0 = OK or Open Circuit\n1 = Short to Ground\n2 = Short to Plus
;
080,0,Advanced Control Module Identification I
;
081,0,Advanced Control Module Identification II
081,1,Serial Number
;
 

·
Registered
Joined
·
1,624 Posts
These codes are for the C6 A6 with MOST network. I'm not sure they work with the CAN based sat tuners. What vehicle do you have?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top