Audi Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
515 Posts
Discussion Starter · #1 ·
i just got my new adapter harness and my front speakers arent working..

i noticed a couple of potential problems with my adapter..
-- the front speakers on connector A wired correctly..
-- but the front speaker line outs on connector C are also wired in..
-- lastly, the Bose pin is wired to ground - is that correct??..

i am guessing either the front speaker line out should be disconnected; the Bose pin should be disconnected or the coding is wrong??..

the coding i am using is 0301111..

i know the RNS-E front channels are good because i was borrowing an incomplete harness until this one arrived and only the front speakers worked.. (old style adapter that did not have K-line, had lose CAN-BUS wires, no CDC, no phone, ect -- just connectors A & D)..

FYI::
Symphony II to EU RNS-E installed in A4, w/o Bose

any ideas??.. thanks..
 

·
Registered
Joined
·
515 Posts
Discussion Starter · #3 ·
thanks!!..

for Bose vehicles is the Bose pin connected to ground or _________??..
 

·
Registered
Joined
·
515 Posts
Discussion Starter · #5 ·
Awesome!!!..

that should do the trick..

hopefully i will have time to test it tonight.. whenever i verify it, i will post the results..

thanks again..
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top