[David A4B6]

Hi,

Not that hot on my electrics, where abouts can you get the 12v switched supply for the Nav in an A4 B6?

Regards

David

 

[TeddyBGame]

david,
see my pix below. You can tap into a switched/ignition source underneath your fuse box/relay area.

-ted

 

[David A4B6]

12v switched

Ted,

I see your pic which identifies ignition as 75x and Battery as 30x, is it one of those 4 connectors in that row?

http://www.vwnavi.com/vwnavi/photos/displayimage.php?album=58&pos=8

Don't suppose you know what its marked as?

Many Thanks

David

 

[TeddyBGame]

I don't understand your question. I think you answered it...already.

75X = ignition. The bolt that is below the "75x".

I can't make the picture any clearer than that.


-ted

 

[jjacob2]

Ted:

If i pull out my navi plus, what wires should I look for in block III to get the ignition off wired correctly?

 

[TeddyBGame]

...look at my pix again and look at the Sym II to Nav+ pix.

Have you seen this site before? Answer within:
http://www.nav-plus.com/instructions/a4b6.html

-ted

 

[David A4B6]

OK, on the A4 B6 (UK spec) fuse 5 is 12v switched, I think it is for heated washer jets.

http://www.tyresmoke.net/ubbthreads...,25,26,27,3/Number/398670/page/0/fpart/2/vc/1

That thread on Tyresmoke mentions it and it worked for me. Needless to say best check it out first.

Teds Link does have a nice little table matching the Symphony wires and the Nav plus wires. If you have one of these rather mis-named 'plug and play' leads its easy to tap into it with the 12v without messing with the factory wiring.

Best of luck
David