Audi Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
5,817 Posts
Discussion Starter · #2 ·
additionally those are engineering codes for D600:

*#06# IMEI number
*#1111# S/W version
*#1234# Firmware version
*#2222# H/W version
*#232337# Bluetooth address
 

·
Registered
Joined
·
49 Posts
Are you saying that the latest firmware for the D600 is now fully compatible with the RNS-E? Does it share the phonebook and call log now?
 

·
Registered
Joined
·
5,817 Posts
Discussion Starter · #4 ·
Can't say for 100% but from what I heard, the latest one is D600EXBEK4 and it is a little bit better than rest of them. I believe it is also unbranded.
 

·
Registered
Joined
·
5,817 Posts
Discussion Starter · #5 ·
UPDATINg FIRMWARE in D600

You also need a flashing serial cable.

The instructions are below:

The process takes around 90 min. Save the correct D600 flash file to your hard drive. Make sure your D600 battery is fully charged. Connect a 9v battery to the serial cable, it must be a brand new battery as this process takes approx 90 min, and if the battery fails you will kill your phone. Power off the phone with no sim inserted and connect the phone to the serial cable and the serial cable to your PC. When flashing D600 make sure you select 1gone at the top.
Select correct com port. Com speed should be 115200.
Select the BIN + TFS radio button.

D600 users press the BIN button and open the "D600XAEJ4.cla" file (it can be different depending on the flash version).
Orange or D600E users press the BIN button and open the "D600EXBEK4.cla" file.

D600 users press the TFS button and open the "D600XAEJ4.tfs" file.
Orange or D600E users press the TFS button and open the "D600EXBEK4.tfs" file.

Click Start.
Tap the power button on the phone when prompted. The phone should not turn on, but software will recognise the ignition. Phone will connect, and the "Download" button will now be highlighted.
Click the download button and the flash will begin.
Once flash has finnished, press stop.
When the phone is successfully flashed take out and replace the battery and then power on.

After the debrand process some models when powered up do not display correctly, ie white screen, no graphics, only text.
Solution: insert a sim card and power the phone up.
Press the menu key.
Move to bottom right (settings) and select it.
Select reset settings.
Select all and then reset.
Pasword is 00000000 (eight zero's).

Notice for users who killed their phones for not making sure their battery was fully charged:
If you do kill your phone, it is not the end of the world. You cannot charge your battery like you normally would when the phone is dead, it simply will not charge.
The solution is to borrow a D600 battery from a friend (make sure it's fully charged first) and use that battery and repeat the flashing process.
Once the debrand process has finished, this will bring the phone back to life all nice and de-branded.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top