Audi Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
3,759 Posts
Discussion Starter #1
Audi S8 wiring for telephone kit and CD changer, CANBUS leads and GALA

A: Speaker Connecter
1 - N.C. (steht für Not Connected)
2 - rechts vorne +
3 - links vorne +
4 - N.C.
5 - N.C.
6 - rechts vorne -
7 - links vorne -

B. EXT Control Connector
1 - Most Ring break
2 - CDC-NF GND ---------------------------- Connector 1 – CD GND - Pin 18
3 - V-Signal --------------------------------- Connector 3 – Gala – Pin1
4 - U14R-2 ----------------------------------- Connector 1 – CD +12V – Pin 16
5 - K-Line ----------------------------------- Connector 3 – K-Line – Pin 3
6 - CDC-Data out --------------------------- Connector 1 – CD Data Out – Pin 14
7 - BOSE Pin -------------------------------- Connector 1 – GND – Pin 8
8 - CDC-NF links IN ------------------------- Connector 1– CD Left – Pin 19
9 - CDC-NF rechts IN ----------------------- Connector 1– CD Right – Pin 20
10 - U14 ST CDC ---------------------------- Connector 1– CD Acc – Pin 17
11 - CDC -Data IN --------------------------- Connector 1– CD Data In – Pin 13
12 - CDC- Data CLK ------------------------- Connector 1– CD Data CLK – Pin 15

C: EXT Control Connector
1 - MIC IN (-)
2 - RFSL
3 - Line Out vorne links --------------------- Connector 1 – Out LF – Pin 4
4 - MIC Out (-)
5 - Line Out hinten links -------------------- Connector 1 – Out LR – Pin 1
6 - TEL NF IN (-) ---------------------------- Connector 1 – Tel- - Pin 12
7 - MIC IN (+)
8 - Line Out GND ---------------------------- Connector 1 – GND – Pin 3
9 - Line Out vorne rechts ------------------- Connector 1 – Out RF – Pin 5
10 - MIC Out (+)
11 - Line Out rechts hinten ----------------- Connector 1 – Out RR – Pin 2
12 TEL NF IN (+) --------------------------- Connector 1 – Tel + - Pin 7

D: Power Connector
9 - CAN-H ------------------------------------ Free wire to connect to infotainment canbus-H
10 - CAN-L ----------------------------------- Free wire to connect to infotainment canbus-L
11 - TEL-Mute ------------------------------- Connector 3 – Tel Mute – Pin 2
12 - Kl.31 (Masse) ---------------------------- Connector 3 – GND – Pin 8
13 - U14 ST DSP (radio On)
14 - DWA-GND
15 - Kl.30 ------------------------------------ Connector 3 - +12V – Pin 7
16 - U14R-1

Additional For CD changer - Connector 1 – CD GND – Pin 10 to Connector 3 - Pin 8
 

·
Registered
Joined
·
6,767 Posts
craigyb said:
D: Power Connector
9 - CAN-H ------------------------------------ Free wire to connect to infotainment canbus-H
10 - CAN-L ----------------------------------- Free wire to connect to infotainment canbus-L
11 - TEL-Mute ------------------------------- Connector 3 – Tel Mute – Pin 2
12 - Kl.31 (Masse)
13 - U14 ST DSP (radio On)
14 - DWA-GND
15 - Kl.30 ------------------------------------ Connector 3 – GND – Pin 8
16 - U14R-1 ---------------------------------- Connector 3 - +12V – Pin 7
Can you confirm that you connected D15 (KL 30) to ground and D16 (U14R-1) to 12V+? I think D12 (KL 31) is ground and D15 (KL 30) is 12V+.
 

·
Registered
Joined
·
3,759 Posts
Discussion Starter #3
Does that look better, they are very important, but I was doing them from memory, so a big mistake on my part, would have been better with the lead in my hand, but it's in my dash :)

I've corrected it now. apart from those 2 very important cables, the rest of it is correct.

Craig
 
1 - 3 of 3 Posts
Top