Audi Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Hi,

Thanks for this fantastic resource. I have now retrofitted an A6 RNS-E to my A2. I have one outstanding issue though. I cannot get VAG-COM to accept certain codes.

For instance, the details on the OpenOBD site show the follow adaptation for STG 56:

-> Channel 136 (Voice commands)
00005 - LHD (USA)
00013 - RHD (USA)
02632 - RHD (Europe)
03226 - LHD (Europe)

It was provided as 3226 - and I wanted to change this to 2632 (as I'm based in the UK). When I enter the value and hit Test - the system just redisplays 3226 and doesn't allow me to change it.

For now, I have recoded at 13 - but I'm not sure what the US part would mean to the code - I really want this to show 2632.

Another example is setting a code to 0. For example, the OBD site shows:

-> Channel 002 (GALA)
0 - Self calibration
8 - Audi A6 (4B)
43 - Audi A3 (8P)
45 - Audi A4 (> 2004)

If I enter 0 into VAG-COM, then the Test & Save buttons are greyed out. How do I reset this channel to be 0? I imagine the other options are not suitable for an A2.

FYI, I am using the latest VAG-COM (Release 607) with my genuine Rosstech HEX-CAN+USB adaptor.

Thanks,

Ben.
 

·
Registered
Joined
·
6,767 Posts
Some of those values are only valid for the 0050 Euro software, the canot be coded in newer versions of the RNS-E software anymore. I have never been able to code 0 or 8 in channel 002 (with US sw 0040 or 0110), just 43 or 45. Doesn't seem to be that bad as the RNS-E adjusts itself over time to the correct speed signal.
 

·
Premium Member
Joined
·
11,350 Posts
drn said:
For instance, the details on the OpenOBD site show the follow adaptation for STG 56:

-> Channel 136 (Voice commands)
00005 - LHD (USA)
00013 - RHD (USA)
02632 - RHD (Europe)
03226 - LHD (Europe)

It was provided as 3226 - and I wanted to change this to 2632 (as I'm based in the UK). When I enter the value and hit Test - the system just redisplays 3226 and doesn't allow me to change it.

For now, I have recoded at 13 - but I'm not sure what the US part would mean to the code - I really want this to show 2632.
I found this when I was recoding my new RNS-E which was running SW 0460.

When I was running EU SW 0050 on my old RNS-E (HW 047) it accepted the 2632 and 3226 values, but when running EU SW 0460 on my new RNS-E (HW 070) only 5 and 13 are accepted. I've coded 13 and it works absolutely fine - the navigation instructions come from the right front (drivers - I'm in the UK) speaker.
 
1 - 4 of 4 Posts
Top