Audi Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hi,

I install a RNS-E in an Audi A6 MY2003 with a concert II unit. The Concert II hade GALA.

Everything is working fine (lights, turns off with key, gps signal, FIS display, sound front and rear), execpt the sensor speed signal.

I'm confused, I check the harness, and it looks OK. If the concert hade GALA, should RNS-E hade GALA? Do I have to wired the speed signal from instruments cluster?

I hadn't the change to vag the RNS-E because I used vag-com 311, and it look's like it doesn't support the RNS-E, could this be the problem?

Please help,

Thanks
Bru
 

·
Registered
Joined
·
1,624 Posts
Your GALA wire can be used for the V-signal pin on the RNS-E.

It is possible that your RNS-E is not coded for the "A6" body and if not it will not look for the speed on the V-signal pin but instead will be looking for speed over CAN. This would also create your problem.
 

·
Premium Member
Joined
·
11,350 Posts
Bru said:
I hadn't the change to vag the RNS-E because I used vag-com 311, and it look's like it doesn't support the RNS-E, could this be the problem?
You need to use a later version of VAG-COM. The latest is 5.12-4
 
1 - 3 of 3 Posts
Top