Audi Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
128 Posts
Discussion Starter · #1 ·
I just installed my RNS-E and no matter what I program my car to do I can not get the navigation routes to show up on the cluster screen. Do you have to press a button or am I coding wromg. I get no error when trying to connect to the car. I have no idea what is wrong. 2004 B6 A4
 

·
Registered
Joined
·
6,767 Posts
Turn on the compass in setup and wait until tomorrow. Some reported that it takes a while before the new settings work.
 

·
Registered
Joined
·
128 Posts
Discussion Starter · #3 ·
thanks, so if I do not have my bluetooth nodule istalled yet should my coding be 5 in vag-com?
 

·
Registered
Joined
·
6,767 Posts
Depends what it was before, some are 1, some are 17. In any case you have to add +4 to get the Navi display to work. Also, if it doesn't work tomorrow, start route guidance and if it doesn't show up, turn the RNS-E briefly (like a double click on the mouse) off and back on.
 

·
Registered
Joined
·
6,767 Posts
19 = 16+2+1 , do you have an OEM phone interface? Anyway, if it was 19 then 23 is right.
 
1 - 7 of 7 Posts
Top