Audi Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter · #1 ·
Was trying the firmware upgrade for 2003/09/10 mentioned on another thread.

When I started the procedure it failed with a Error / Timeout Error on the blue screen when it was checking the data and then went back to the Firmware screen showing Error 0007.

Subsequent attempts to eject this CD fail after various power on/off. Its as if it does not know the firmware CD is still inside it.

Any ideas ?

Dave
 

·
Registered
Joined
·
15 Posts
Discussion Starter · #2 ·
Of course when I go to move the car into the garage it pops out by itself.

Looks like it was the thickness of the CDR that was to blame. I'll see if I can find some thinner ones.

This just leaves the problem with the timeout when it tried to load. ANyone had this - just a CD burning issue ?

Dave
 

·
Registered
Joined
·
4 Posts
DaveS said:
Of course when I go to move the car into the garage it pops out by itself.

Looks like it was the thickness of the CDR that was to blame. I'll see if I can find some thinner ones.

This just leaves the problem with the timeout when it tried to load. ANyone had this - just a CD burning issue ?

Dave
Make sure you burn it as "x1" / single speed from whatever CD burning software you are using - The RNS-D like slow burnt disks better.
 
1 - 3 of 3 Posts
Top