PDF manual for older D Nav H version
Join the discussion
Recommended Reading
-
Engineering mode for Audi Navigation+ RNS-E
Knowledge Base1) Turn on RNS-E. 2) Press the NAV button and release. 3) Press the top-left cursor button for 5 seconds and release. 4) Press the top-right cursor button for 5 seconds. Hold until the screen changes. [siteimg:c0413e680d]38[/siteimg:c0413e680d] [siteimg:c0413e680d]39[/siteimg:c0413e680d]...- 32
- 51K
-
Catalogue with Audi specifications
Knowledge BaseSpecs of majority of postwar Audi cars: AUDI specs&performance: automobile-catalog.com Hope it will be useful...- 6
- 2K
-
Vag_Com Bench Programing Harness for RNSE
Knowledge BaseHello all I'm trying to make a harness to bench program my RNSE outside of the vehicle. I know it can be done and I've seen it in some photos but no actual data on it could be found. I know all I need is CAN H, Can L, Power and Ground on the radio side, however I'm not confident on where to wire...- 2
- 2K
-
RNS-E Motherboard Replacement
Knowledge BaseThanks to a corrupt EEPROM, I recently had to remove and replace the motherboard of my RNS-E. These boards were remarkably helpful (as was "Rabbit" (a.k.a. Cem Ozkan) who supplied the replacement motherboard) but what was lacking was a comprehensive, step-by-step account of how to crack open the...- 6
- 6K
-
Air Filter Code VS Intake Manifold Gasket Code??
Knowledge BaseGood morning, I brought my car in because the Malfunction light was on. Audi claimed that it was from a clogged air filter. The filter is a K&N so they charged me over $300 to "clean" it. The Malfunction light came on again right after I picked up the car from the dealership. They said that it...- 1
- 2K
Join now to ask and comment!