Audi Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
88 Posts
Discussion Starter #1
Is there any OBD Diagnostics in pin on the RNS-E? A OBD Diagnostic connection should be a must if i would like the vag-com to find the unit!? Or am i wrong?
 

·
Registered
Joined
·
3,759 Posts
yes there is "K-Line"
 

·
Registered
Joined
·
149 Posts
The -K- Line is a special pin on your adapter.
Most Audi and VW vehicles redirects this pin directly to the OBD connection underneath the dash.

If your Car does not support a K-line on the connector, you have to run a cable from your unit (Please take a look at the diagram on top) to PIN NUMBER 7 OF YOUR CAR'S OBD CONNECTION.

Good luck,
Tony
 

·
Super Moderator
Joined
·
11,350 Posts
powertony said:
Most Audi and VW vehicles redirects this pin directly to the OBD connection underneath the dash.
Popov is fitting the RNS-E to a Seat Leon.

AFAIK the same is true for Seat and Skoda too.

I wonder if it's also true for the other marques in the VAG Group? (Lamborghini, Bugatti & Bentley)
 

·
Registered
Joined
·
88 Posts
Discussion Starter #6
Yes the K-line is there allready, did not just see it. It has been connected to the RNS-E all the time. I tried first to connect with my vag-com and it found it so i looked around the cables and there it was allready with the KL30 and KL31 cables for 12+ and ground, think it was yellow. Bye the way, PetrolDave i bought this unit from Powertony so he allready knows it is being installed into a Seat, thanks anyway... :D
It is working, just waiting for my cd to try the navi function.
 
1 - 6 of 6 Posts
Top