Audi Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Gentlemen

In preparation of my bluetooth kit from NSXJR, I purchased a Vag-Com and ran it through the autoscan. It is a 2006 S4 w/factory RNS-E, I am receiving this error, any help would be appreciated.

Address 37: Navigation
Part No SW: 8E0 035 192 F HW: 8E0 035 192 F
Component: RNS-E US3 H70 0150
Coding: 0309117
Shop #: WSC 92602

1 Fault Found:
01044 - Control Module Incorrectly Coded
000 - -
Freeze Frame:
Fault Status: 01110000
Fault Priority: 7
Fault Frequency: 1
Reset counter: 174
Time Indication: 0
Date: 2006.12.30
Time: 10:40:42


-------------------------------------------------------------------------------
Address 56: Radio
Part No SW: 8E0 035 192 F HW: 8E0 035 192 F
Component: RNS-E US3 H70 0150
Coding: 0309117
Shop #: WSC 92602

1 Fault Found:
01044 - Control Module Incorrectly Coded
000 - -
Freeze Frame:
Fault Status: 01110000
Fault Priority: 7
Fault Frequency: 1
Reset counter: 174
Time Indication: 0
Date: 2006.12.30
Time: 10:40:42
 

·
Registered
Joined
·
6,767 Posts
The softcoding looks ok, can you list all the adaptation channels (in VAG-COM: Adaptation - 10) and what values are set there?
 

·
Registered
Joined
·
6,767 Posts
Not quite what I was asking for. Check http://www.navplus.us/forum/viewtopic.php?t=73 for all documented adaptation channels (function 10) and then write down the values for each documented adaptation channel and post them here.
 

·
Registered
Joined
·
6,767 Posts
No, on the page I mentioned above, scroll down to "STG 56 -> Adaptation -> Function 10" and check all the channels that are not shown as undocumented. Write down the value for each channel and post it here.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top