Audi Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
Hello,

Hoping this is the right place to post...

Is there anyone which could help me to understand this codes:

Control Module Part Number: 8P0 907 279 F
Component and/or Version: Bordnetz-SG H36 1201

Software Coding: 01884F068214100000000000000000000008FE175C0100
Work Shop Code: WSC 06314
Additional Info: 8P1955119B Wischer AU350 H01 0130

10 Faults Found:

00188 - Control Circuit 1; Relay for Supply Voltage Terminal 50
010 - Open or Short to Plus - Intermittent

00187 - Control Circuit; Relay for Supply Voltage Terminal 75X
010 - Open or Short to Plus - Intermittent

00887 - Switch for Emergency Flasher (E229)
012 - Electrical Fault in Circuit - Intermittent

01064 - Terminal 58d; Interior Dimming
010 - Open or Short to Plus - Intermittent

01800 - Light Switch (E1)
008 - Implausible Signal - Intermittent

02071 - Local Databus
004 - No Signal/Communication - Intermittent

01516 - Terminal 30; Left
011 - Open Circuit - Intermittent

01049 - Supply Voltage Term 50
012 - Electrical Fault in Circuit - Intermittent

00187 - Control Circuit; Relay for Supply Voltage Terminal 75X
007 - Short to Ground - Intermittent

00153 - Left Windshield Wiper Motor (V216)
004 - No Signal/Communication - Intermittent

Thanks
 

·
Registered
Joined
·
6,767 Posts
I would post those codes in the VAG-COM forum on AudiWorld, the Ross-Tech guys are there and have most likely an answer for you. If you post there, mention what version of VAG-COM (both interface and software) as well as what car you have.
 

·
Registered
Joined
·
16 Posts
same problem, did you solve it?

Hi

I got these messages too, but only two of them,

00188 - Control Circuit 1; Relay for Supply Voltage Terminal 50
010 - Open or Short to Plus - Intermittent

00187 - Control Circuit; Relay for Supply Voltage Terminal 75X
010 - Open or Short to Plus - Intermittent

Please did you find the eason why this happens

thing is that my battery goes down easily, i see there is a problem in circuit, but I dont know what is the CAUSE of this problem

Thank you
 
1 - 4 of 4 Posts
Top