Audi Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Hello everybody,

I have just started installing my RNS-E unit to my AUDI S3 from 2000.
As there is no Canbus I have bought an Canbus simulator, but i still need the K-Line and V signal.

Does anybody know where I can find these in the car.

Car is Audi S3 from 2000 (8L)
 

·
Registered
Joined
·
3,759 Posts
K-line should be on the harness already, check you pins. Should be Marked "K" or "K Diagnosis" on the radio lid of the wiring layout

Speed pulse/V-signal/Gala all the same thing. Look for these pins on top of your old radio wiring pin outs.

They may already be there.

If not you can get them both from the cluster, I can look up the pins later for you.

Craig
 

·
Registered
Joined
·
3,759 Posts
According to my wiring diags they are there if your car was built with a radio.

Connector T8/3 - K Line to Green 32 pin cluster connector pin 28.
Grey/White cable

Connector T8/1 - Gala to Blue 32 pin connector pin 31
Green/White cable
 

·
Registered
Joined
·
5 Posts
Discussion Starter · #5 ·
Heard from a nice guy here in denmark:

He also says Gala to Blue 32 pin connector pin 31, but says Gala to pin 7 in diagnostic plug. A germay fellow told me pin 1 in WIWA relais.

Is all 3 options or what is up, I am getting very confused :?

Connection to Green 32 pin cluster connector pin 28, would be much the easiest I think :D
 
1 - 5 of 5 Posts
Top