Audi Forum banner

1 - 14 of 14 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter #1
I've changed steering wheel column module, airbag slip ring, steering wheel. Need to do Steering Angle Sensor Calibration.
Help!
 

·
Registered
Joined
·
595 Posts
Just drive the car for 1 km, it will calibrate itself and then erase the error on the brake electronics control module.
 

·
Registered
Joined
·
595 Posts
If the sensor is installed correctly and there is no other error on the ABS control module it must work.
Please post the VCDS error on the 03-ABS Brakes.
 

·
Registered
Joined
·
20 Posts
Discussion Starter #9
Code:
Address 03: ABS Brakes Labels: 4L0-910-517.lbl
Part No SW: 4L0 910 517 E HW: 4L0 614 517 E
Component: ESP ALLRAD MK25E1 0140
Revision: 00H45001
Coding: 0038033
Shop #: WSC 31414 790 00001

1 Fault Found:
00778 - Steering Angle Sensor (G85)
005 - No or Incorrect Basic Setting / Adaptation
Is it possible to install the sensor is not correct?
The site Ross-tech on VW Passat and Audi A4/S4, A6/S6, and A8/S8: :
[Basic Settings - 04]
Group 001
Q7

Is it Group 004 ?
In Group 004 vcds program does not allow for Basic Setting 04.
 

·
Registered
Joined
·
595 Posts
1. start engine
2. put the car in P
3. move the steering wheel at aprox. 30 degrees left and then back to center.
4. put the car in D
5. drive for 400-500 m.
6. connect the VCDS and erase the error
7. turn ignition OFF and then back ON

This will solve your problem.
 

·
Registered
Joined
·
20 Posts
Discussion Starter #13
found the cause, moved the old block ( 16 - Steering column electronics ) - it works! The new write Fault Found
- Steering Angle Sensor
 

·
Registered
Joined
·
39 Posts
hi, best to do with vagcom and try this
[Select]
[03 - Brake Electronics]
[Security Access - 16]
Enter 40168, to enable the basic setting.
[Do it!]
[Basic Settings - 04]
Group 060
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]
After a successful basic setting, field 2 should say "OK".
[Done, Go Back]
To make sure the basic setting was successful, check the sensor again.
[Measuring Blocks - 08]
Group 004
[Go!]
Check field 1, the value has to be between -1.5 and +1.5 °.
[Done, Go Back]
[Close Controller, Go Back - 06]
 
1 - 14 of 14 Posts
Top