Audi Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
So I changed my clutch after my stock clutch burned up in my 2012 a4. Before it went I had no problems shifting. It was very smooth.
Now that I got my car back together after changing the clutch it’s hard to shift when the car gets hot. When the car is off or cold it will shift into every gear without a problem. It is mainly the lower 3 gears. If the car is hot and I shift from 1st to 2nd I have to wait until the rpms go down before it will shift.
Also after driving a while it feels like the clutch isn’t fully disengaging if I shift into first and keep the clutch pressed in.
I pulled my slave cylinder out today and inspected it. Seemed fine. I also gravity bled it even though I did not disconnect any lines.
If anyone has any other ideas I would greatly appreciate it.
 
1 - 1 of 1 Posts
Top