Well i have been trying to figure out this failure codes and did find a logic explenation to one of theme. I have 3 fault codes and they are:
Control Module Part Number: 8E0 035 192 D
Component and/or Version: RNS-E HIGH EU H70 0360
Software Coding: 0305711
3 Faults Found:
00003 - Control Module
014 - Defective
00858 - Connection; Radio ZF Output to Antenna Amplifier
011 - Open Circuit
01317 - Control Module in Instrument Cluster (J285)
008 - Implausible Signal
Defective control module appeared after my mixing with the can signal but the unit is working without problems. So question is what is wrong?
Connection; Radio ZF Output to Antenna Amplifier, well i don't have it connected and i will not connect it. Question is if i can make it go away bye making some kinde of homemade connection?
Control Module in Instrument Cluster (J285). Well the J285 is the instrument cluster and my thoughts is that the unit is not getting the speed signal in the can signal from the J252. It is getting the illumination and on/off signal but no speed signal. Anybody willing giving me a explenation! Maybe the can interface is in need of some correct coding?
Control Module Part Number: 8E0 035 192 D
Component and/or Version: RNS-E HIGH EU H70 0360
Software Coding: 0305711
3 Faults Found:
00003 - Control Module
014 - Defective
00858 - Connection; Radio ZF Output to Antenna Amplifier
011 - Open Circuit
01317 - Control Module in Instrument Cluster (J285)
008 - Implausible Signal
Defective control module appeared after my mixing with the can signal but the unit is working without problems. So question is what is wrong?
Connection; Radio ZF Output to Antenna Amplifier, well i don't have it connected and i will not connect it. Question is if i can make it go away bye making some kinde of homemade connection?
Control Module in Instrument Cluster (J285). Well the J285 is the instrument cluster and my thoughts is that the unit is not getting the speed signal in the can signal from the J252. It is getting the illumination and on/off signal but no speed signal. Anybody willing giving me a explenation! Maybe the can interface is in need of some correct coding?
