Audi Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter #1
Hi, I received the following codes from a VAG scan which are related to the RNS-E (US version). It's a retrofit into 05 B5 S4. I have had no problems with the system at all, however, so was wondering if anyone might know if these can be fixed by just clearing them? Also, do you think I need to change any of my codings?

Address 37: Navigation
Controller: 8E0 035 192 E
Component: RNS-E US H56 0020
Coding: 0309111
Shop #: WSC 00000
5 Faults Found:
00532 - Supply Voltage B+
002 - Lower Limit Exceeded - Intermittent
00446 - Function Limitation due to Under-Voltage
002 - Lower Limit Exceeded - Intermittent
02024 - Perform Adaptation
000 - -
01316 - ABS Control Module
004 - No Signal/Communication - Intermittent
01044 - Control Module Incorrectly Coded
000 - -

Thanks in advance for the help.
 

·
Registered
Joined
·
6,767 Posts
Never seen those before. Did you clear all faults after installing the RNS-E? The coding 0309111 says you have Bose but no SAT radio, is this correct? The two voltage related errors could point to a bad battery (low voltage while you were installing the RNS-E after having ignition turned on for a while)

You may want to post these error in the VAG-COM forum on audiWorld. There are more VAG experts over there. Also, if it's a 2005 S4 it should be a B6.
 

·
Registered
Joined
·
36 Posts
Discussion Starter #3
Thanks as always, (made a typo on the B5). I actually have SAT connected, it's just not being used. I'll trying changing to include it.
 
1 - 3 of 3 Posts
Top