Audi Forum banner

Engineering mode for Audi Navigation+ RNS-E

61872 Views 32 Replies 23 Participants Last post by  Nerukas
1) Turn on RNS-E.

2) Press the NAV button and release.

3) Press the top-left cursor button for 5 seconds and release.

4) Press the top-right cursor button for 5 seconds. Hold until the screen changes.

[siteimg:c0413e680d]38[/siteimg:c0413e680d]

[siteimg:c0413e680d]39[/siteimg:c0413e680d]

[siteimg:c0413e680d]40[/siteimg:c0413e680d]

check for more pictures in ALBUM
1 - 2 of 33 Posts
Engineering mode

Anyone that can explain what to do, or us this mode for, or NOT do in engineering mode?
There are some settings here and there, but I have not been able to find out what these are used for...


I've tried to find out different things, but not so much useful things:
Snap-shots of screen
Reading actual speed
Use FF as PTT if you don't have MFSW.
Look at some status signals

Anything else useful??
See less See more
Yes, I have read this thread, and also German, English, Swedish, Norwegian and Danish Audi pages, and my own two years fiddling with the RNS-E, but I'm still curious about most of the different settings in Engineering mode, and what their purposes are.
1 - 2 of 33 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top