Audi Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
51 Posts
Discussion Starter #1
I installed RNS-E into my 2002 allroad few months ago, recently I was browsing through the "engineering mode" and decided to test the reverse signal. Although my wire is connected according to TeddyBGame's and Lee Hick's directions, it seems like the unit is not seeing the reverse command. Anybody here with C5 platform cars and MK-II RNS-E experimented with it?

Thanks,
 

·
Registered
Joined
·
3,759 Posts
Depends which model of mk2 unit you have, the A3 rev B units are ok, I have one in my A2 and the speed signal and reverse work ok. The later G units do not work.
 

·
Registered
Joined
·
3,759 Posts
My reverse works as when I go into reverse it switches to my camera view.
 

·
Registered
Joined
·
11 Posts
I have noticed the same issue with reverse not showing any activity in engineering mode. Does the rnse need to be coded for lambo mode or a4 in a c5 vehicle to get reverse to work, especially if adding a rear view camera
 
1 - 5 of 5 Posts
Top