Audi Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
95 Posts
Discussion Starter · #1 ·
Hi

Today I was trying to coding a BT module (rev D) with latest VagCom, but there is some problem and I can do it. It's coded wiht 0000755, I can code it to 0000555 (so I can access to the module) but not to 0010755.

I don't know it the 0 (RNS-E Basic) or 1 (RNS-E High) is important or not, but all units I've seen are coded with 1.

Any idea of how to code it?

The second problem is this: when the module pairs with the phone, the RNS-E shows [SIM] at the bottom of the screen, and the TEL option shows "please, insert the SIM card". The module works partially (you can receive incoming calls), but can't access to the directory.

I've chequed #134 and is ok (0), any idea?

Regards
 

·
Registered
Joined
·
6,767 Posts
The "D" phone interface doesn't support "high" coding, so all you can do is 0xxxx. You can also not code the RNS-E to 0xxx7xx (high), otherwise you get the SIM error. Try 0xxx2xx or 0xxx3xx for a "low" phone integration. Similar is try for the "E" phone interface and the one without any index letter.
 
1 - 3 of 3 Posts
Top