Audi Forum banner
1 - 3 of 3 Posts

· Registered
121 Posts
Discussion Starter · #1 ·
in taylors B5 installation instructions he says

" Using the wiring diagram on top of the unit, find the D connector and locate pins 9 and 10 of this connector. These are the CAN H and CAN L connections to the RNS-E unit, respectively..."

I dont have the unit yet and i am trying to get all the work done before it arives so i can just plug it in. I have the CAN H / L coming from the cluster and i just need to know what wires to cut from the harness to connect them to. It seems that 9 is in the middle on the outside row... and 10 may be below it, but I want to know for sure before i go cutting wires. (pictures would help the best)
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.