Audi Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
32 Posts
Discussion Starter · #1 ·
I have my RNS-E w/ software ver 150, it works just fine. I want to know if there is a way to recode the cluster LCD so that every time I start up the car it goes to the normal section vs the Nav section?

Thanks,
Edy
 

·
Registered
Joined
·
72 Posts
Follow-up question...

Edy, do you have the OEM B5 cluster?

I installed mine this afternoon and I don't have a display in the cluster... And the Compass is set to on in the display settings...
 

·
Registered
Joined
·
72 Posts
Edy-Jun said:
Yes, i have the B5 cluster... i think you need to recode the cluster and the RNS-E.

Edy
I did the firmware update using Lee Hicks update CD, and I am using a 2007 Map disk. I have a full custom harness from Teddybgame and a new cangate. Part of the software update was a VAG mod...but I don't know if that was a recoding or just to allow the RNS-E to accept the update.

What/how did you recode the cluster?
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top