Audi Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
So I have been working on upgrading the rear tail/turn signals on my 2008 A3 to LED Bulbs. I installed the rear turn signal lamps along with a load equalizer for each one. All working fine. When trying to upgrade the tail/brake light lamps (Left side pin 1,pin 2-Right side pin 3,pin 4) the inner bulbs(closer to center of car L-pin 2,R pin-3) turn off after a few seconds when powered on. Do I need a load equalizer on each bulb? Is there another option that doesn't involve me having to install more equalizers? I do have a ross-tech dongle but I've only performed a scan of fault codes because I just purchased this car a few weeks ago and have no clue what the capabilities are. Just want to have these bulbs all work and not have the fault on my dash.
 
1 - 1 of 1 Posts
Top